WPAudio Engine Tool
Measure a recording
For songs and albums: choose a track, or the tracks of an album one at a time, and the engine measures it here, in your browser, and tells you what it found in plain words. Longer recordings work too; they take longer.
Released Engine 0.1.1
Measure a recording
This tool runs in your browser and needs script to do so. Everything else on this page reads without it.
Choose a recording to measure. It stays on this device.
Measure
Your recording stays on this device: nothing is uploaded.
WAV, AIFF or FLAC, mono or stereo. Up to 3 hours; a WAV or AIFF file up to 4 GB, unless it is a WAV in RF64 form. Past a limit, the tool stops and says why.
Report
No report yet. Choose a recording under Measure; its report appears here.
What the engine found
What to check
All measurements
| Measurement | Value | How it is measured |
|---|
Keep either file with your recording. Later, this tool or the engine’s command line can measure the recording again and say whether every value in the report is still true of it.
If this keeps happening, you can tell the agency. Copy the details below and paste them into a message: they hold the engine version, this browser and the error code, and nothing about your file.
Check a saved report
Choose the recording above, then the report you saved for it. The engine measures the recording again, here, and says whether the report is true of it. The recording is chosen under Measure.
What happens to your file
Your recording stays on this device. The engine runs in this browser and reads the file here; nothing of it is uploaded, to this site or anywhere else, and nothing is sent while it is measured.
Your file is not changed. The tool only reads it and describes it; it writes nothing back.
Nothing is kept. The site stores nothing about your file, sets no cookie and does not remember what you measured. Close the page and it is gone. The report is yours to save, on your own device, if you want to keep it.
The measuring program is downloaded from this site once, when you start, and checked against the fingerprint it was published with before it runs. After that the tool needs no connection: you can switch the network off and it still measures.
Before you start
- Files: WAV (floating point included), AIFF, AIFF-C and FLAC, in mono or stereo. A file with more than 2 channels, or in a lossy format such as AAC or Opus, is refused before it is measured, with the reason.
- Sample rates from 8 to 192 kHz. The measurements are tested at 44.1, 48, 88.2, 96, 176.4 and 192 kHz; at any other rate the report says so.
- A WAV or AIFF file over 4 GB can be exported from your audio program as FLAC, or as a WAV in RF64 form (also called BW64). The tool reads both.
- How long it takes depends on the device. On the laptop it was measured on, a ten-minute stereo file took about 12 seconds in Chromium, the browser engine of Chrome. Phones have not been measured yet: a slower device takes longer, the bar shows how far it has read, and Cancel stops it at once.
- The tool does not play your recording and does not change it.
How to read the result
The result starts with one sentence: the most important thing about the recording. Then come the points worth checking, the most serious first, each with what it is, why it matters and what to do. Then every measurement, with how it is measured.
The report also says what it cannot tell you: whether the music is good, or what a streaming service will do with it tomorrow. Where it compares your recording with a service, it names the service and says what the service says it does; that is information, not a target to aim for.
The saved report is a single page you can open in any browser, print, or keep. It holds every value, so the tool can check it against the recording later: choose both under "Check a saved report".
How the measuring works, what it is checked against and how closely, and the open-source code inside it.